pi 

 

install 

 

faq 

 

 

 

 
Application Notes

Easy as 1-2-3 Step 2-Connect the IRCaster

The IRCaster sends electrical power to the CableCaster. The IRCaster also allows you to control home entertainment devices from another room. The IRCaster is usually installed in a room where you want to remotely control your devices.
caution_2

CAUTION

DO NOT plug the IRCaster Wall Adapter into the electrical outlet until you complete the "Step 3.  Install the CableCaster" section.

The IRCaster could be damaged if you plug it in before the CableCaster is installed in the network and you connect the IRCaster to the CableCaster.
caution_202

Caution

The first or only IRCaster that is installed in a home network MUST have a direct cable run to the CableCaster. There cannot be a splitter between the IRCaster and the CableCaster in order to prevent damage to the IRCaster.
  1. Connect a TV to the IRCaster TV    port.
  2. Connect a coaxial cable from the IRCaster NET port (the port with the green dot) to the cable wall outlet.
  3. Plug the IR Detector into the IR     receptacle.
  4. Position the IR Detector lens so that it will be in direct line with the remote control.
  5. Plug the Wall Adapter into the IRCaster.
    WAIT! DO NOT plug the Wall Adapter into the electrical outlet until you have completed the CableCaster installation in the next section.

Note:
This connection provides electrical power to the IRCaster, which also provides electrical power remotely to the CableCaster.

Terrific! 2 steps done, and 1 to go!
IRCaster_1

  Download a PDF version of our Easy 1-2-3 Manual

  Investigate various room configurations

  Jump to Step 3

  Back
[CrossBar Media and Avcast Media Kits] [Customer Comments] [General Information] [Technical FAQ] [How AVCAST Technology works] [Technical Specifications] [Purchase information] [Media Kit] [Installation and Technical Support] [Contact Us]

Copyright © 2005, CrossBar Media™, All Rights Reserved